SECO-LARM USA - SD-961A-36

Below are all the different types of SECO-LARM USA. Select the device of your choice, to download the manual

Click here to download the manual

Contents

b The height of the push bar from the floor may be subject to local regulations c The best looking installation will have the push bar centered on the door as measured from the left and right However before drilling the holes make sure the door opens and closes properly If not it may be necessary to adjust the push bar to the right or left a bit This must be checked with the aluminum top and its end caps on 4 With a pencil mark the four bolt or screw holes and the hole for the wires on the door and put the push bar to the side Note If the push bar was cut make sure the end cap on the base unit is set firmly against the base unit before marking the holes 5 Drill a 3 8 10mm hole in the door for the wires Do not drill all the way through the door 6 ...
Click here to download the manual

Contents

b The height of the push bar from the floor may be subject to local regulations c The best looking installation will have the push bar centered on the door as measured from the left and right However before drilling the holes make sure the door opens and closes properly If not it may be necessary to adjust the push bar to the right or left a bit This must be checked with the aluminum top and its end caps on 4 With a pencil mark the four bolt or screw holes and the hole for the wires on the door and put the push bar to the side Note If the push bar was cut make sure the end cap on the base unit is set firmly against the base unit before marking the holes 5 Drill a 3 8 10mm hole in the door for the wires Do not drill all the way through the door 6 ...